UP FOR SALE IS OUR BIG-POD 1 LITRE SNIPER-PERFORMANCE & WALBRO CUSTOM BUILT BIG-POD FUEL PUMP ASSEMBLY TO SUIT FALCON FPV BA, BF UTE XR6, XR8 UP TO 09-2007.

FITTED WITH GENUINE USA WALBRO 460-LPH TIA485-2  750 BHP SUITED FOR E85, E100, METHANOL & PUMP FUEL PERTOL.  

THIS ASSEMBLY IS CUSTOM MADE AND ONLY AVAILABLE BY SNIPER PERFORMANCE, FITTED WITH A GENUINE WALBRO 460-LPH TIA485-2 F859 AND CAN SUPPORT UP TO 750 + BHP AT THE FLYWHEEL.

THE NEW GENUINE 460LPH TIA485-2 WALBRO MADE IN THE USA. 

The NEW WALBRO E85 460-LPH TIA485-2  pump one of the most highest flowing in-tank fuel pump on the market, and is E85 & Methanol approved. Walbro designed the pump to meet the  requirements of modern turbocharged applications where a single 255LPH fuel pump is insufficient.  The pump uses a turbine style design which incorporates two composite plastic blades. The turbine design lends itself to extremely quiet operation and a massive flow rate.

OUR SNIPER PERFORMANCE ASSEMBLY IS CUSTOM MADE IN THE POD AREA WE HAVE INCRESED THE VOLUME FROM 500ml TO 1 LITRE. MADE TO STOP SURGING UNDER EXTREME TAKE-OFF'S AND AROUND CORNERS WHICH IS A COMMON PROBLEM WITH THE FACTORY SWIRL POD AFTER FITTING A BIGGER PUMP. THE FACTORY UNIT HOLDS 500-ml NOT ENOUGH FUEL FOR A AFTERMARKET HIGH FLOW PUMPS THAT CAUSES THEM TO SUCK AIR AND SURGE UNDER HARD TAKE-OFFS & CORNERING WITH HALF A TANK ORE LOWER, OUR ASSEMBLY IS MADE AND MODIFIED TO STOPS THE SURGING PROBLEM BY 100%.

CHECK OUT THE PICTURES ON THIS LISTING BELOW. 

IT HAS BEEN DYNO, RACE TRACK TESTED, 1/4 MILE, CIRCUIT AND DRIFT.

THIS ASSEMBLY CONSIST OF ONLY THE BEST OF THE BEST PARTS AVAILABLE AND HAND ASSEMBLED AND MODIFIED IN MELBOURNE. 

THE CHEMICAL COMPOUND OF THE POLLIMER IN THIS ASSEMBLY IS MADE BY DUPONT GERMANY MADE FOR E85 & METHANOL. WE ARE THE ONLY ONES THAT OFFER THIS BIGGER ASSEMBLY FOR THE FORD BA, BF UTE.

THE FUEL HOSES USED IN THIS ASSEMBLY ARE MADE IN THE EU THE  BLACK FEED E85 HOSE IS A LINED 2 LAYER HOSE MADE IN GERMANY THAT HAS A 3X BURST PRESSURE OF THE STANDARD HOSE. THE WHITE RETURN HOSE IS RATED AT TWICE THE BURST PRESSURE OF THE FACTORY HOSE AND BOTH ARE HIGH FLOW. 

WE SPECIFICALLY FIT THE PUMP WITH A NEW DELPHI FACTORY WIRING PLUG (NO JOINS ON PUMP) WITH STAINLESS STEEL TERMINALS. 

2 X STAINLESS STEEL COMPRESSION SPRING & GUIDE PINS FITTED FOR NO CHANCE OF CORROSION. 

E85 HIGH MICRON HIGH FLOW NYLONG STRAINER FOR MAXIMUM FILTRATION AND FLOW.

HIGH FLOW MODIFIED VENTURI HOUSING & FUEL RETURN JET-VALVE TO KEEP THE RETURN PRESSURE LOW AS POSSIBLE & TO KEEP THE SWIRL POD LEVEL FLOWING 3X THE NORMAL RATE.